2 2
Use
Transport Safety
Transport SafetyTransport Safety
Transport Safety
- For transport the chipper should be coupled to transport means equipped
with towing brackets with a joint ball of size ISO 50.
- Having coupled the chipper, plug the traffic lights.
- Checks before drive:
lights
tire pressure
machine for completeness
locking of turnable parts against turning (discharge duct)
locking of hinged part of loading chute in transport position
rear registration plate legibility
condition of towing bracket/hitch and overrun brake (rope of
overrun brake must be attached to towing vehicle).
- It is strictly forbidden to transport the chipper with its engine on.
- It is not allowed to transport any objects or loads on the chipper.
- Never couple another machine to the chipper.
- Keep the traffic lights clean.
- Avoid any damage of the traffic lights.
- If necessary, remove all mud and other deposits always before coming to
a public road.
- Check auxiliaries for completeness (e.g. scotch blocks).
- Check the wheel nuts for proper tightening.
- Putting the chipper aside block it against unwilling motion by means of the
parking brake system and scotch blocks and mark it as a transport
obstacle.
- While going on public roads keep all applicable traffic rules not to
endanger other road users.
- While working on a public road, use always prescribed road signs for road
works.
- While working along public roads, keep the direction of ejected chips away
from other road users and avoid any road fouling.
- In case of any fault repair the machine always off the road.
- While repairing, avoid any site fouling (oil products, dirty rags).
To Next Page
Loading...
