Laski LS 150 D - Putting the Chipper into Operation

2 5
- Start the machine always without its chipping device being engaged
(loosen the V-belts). Do not start the machine in confined or ill-ventilated
spaces.
valid only for LS 150 DW: - fill up the cooling liquid only if mixed for -20°C.
The optional breaker, as shown in this auxiliary view, is installed on the output
opening and close to the blade in order to break the transversely cut wood
slices.
The breaker is not included in standard machine delivery
RECOMMENDATION:
The breaker should not be used for small and short wooden pieces, leaved or
coniferous branch wood (with low weight) that may bring fouling due to
shortage of woody mass. To clean the fouled ducting, just put some more
woody materials in the loading chute.
Putting into Operation
Putting into OperationPutting into Operation
Putting into Operation
Before start check up if the loading chute is free of any materials.
Direct the discharge duct out of possible motion of other persons or
prevent other persons to enter the working area. At work proceed
always very carefully.