3 2
Recommendations:
Should the loading rolls be frequently turned off while chipping, it means
that there is too much material loaded and the chipping device is
overloaded. To avoid this overloading:
- reduce volume of material to be loaded, or
- reduce in-feed speed of the loading rolls
The loading rolls in-feed speed can be reduced by the regulating screw (see
arrow on the following figure) under the hinged part of the loading chute. To
change the in-feed speed, just turn the regulating screw accordingly.
Noise and Vibrations
Operation of this chipper brings following emissions:
Measure unit Value
LS 150 D LS 150DW
Noise dB(A) 92,2
92,2
Sound power - measured
- guaranteed
dB 108,3
109,0
108,8
110
All measurements taken in accordance with: EN ISO 11201
EN ISO 3744
While working, the person operating this machine is obliged to use personal
protective equipment efficient against the given noise accordingly.
To Next Page
Loading...
