Laski LS 150 D - Putting the Chipper out of Operation; Emergency Procedures

2 9
Putting
PuttingPutting
Putting out of Operation
out of Operationout of Operation
out of Operation
If you want to stop the engine running or to stop chipping:
- In case of loaded material wait for emptying of the loading chute.
- Reduce the engine speed by the accelerator lever and wait for real speed
decrease (delayed by rotor run-out).
- Pull out the STOP switch and hold it pulled out for a moment. Turn the
switch key in the STOP position.
- Release V-belts tension of the chipping device.
(valid only for LS 150 D)
You may put the chipper out of operation also in this way:
- Reduce the engine speed by the accelerator lever and release V-belt
tension of the chipping device simultaneously.
- Pull out the STOP switch and hold it pulled out for a moment. Turn the
switch key in the STOP position.
Warning! After release of the V-belts tension the rotor of the
chipping device runs out .
Do not disconnect the battery or its disconnector while the
engine is still running – risk of machine damage!
Emergency Situations
Emergency SituationsEmergency Situations
Emergency Situations
Put the chipper out of operation immediately in following cases:
- If any person or animal approaches under 20 m while chipping, then stop
working immediately.
- If any breakage, damage or disengagement occurs, stop chipping
immediately.
- If you heard any strange noise or vibrations or felt a strange smell while
chipping, then turn off the machine immediately and contact your dealer or
directly the manufacturer.
- In case of fire or breakdown, stop chipping immediately.
- In case of fire use foam extinguishers only.
- If you cannot damp the fire down yourself, call for a fire brigade.
- If an attending person gets caught by rotating parts or loaded materials
stop the loading rolls by pushing the safety frame. Stop working and go on
only if the attending person is uninjured and fully concentrated.
- If the discharge duct gets clogged, stop loading immediately and reverse
the loading rolls by pushing the safety frame. Turn the chipper off and