Laski LS 150 D - Chipping Wheel Drive; Loading Device; Engine Specifications; Maintenance and Servicing

3 5
Chipping wheel drive 3 belts B17x 1250 Li
Power m3/h about 12
Loading device:
Inlet hole size mm 290 x 220
Number of loading rolls - 2
Diameter of rolls mm 190
Feeding speed m/min 12 - 40
Driving unit - hydrostatic
Speed regulation - NOSTRESS
Loading chute:
Angular adjustment - 5 positions / 120
o
Feeding profile mm 920 x 800
Engine:
type
LOMBARDINI 9
LD 625-2
four-stroke,
air-cooled
LOMBARDINI
LDW
1603 four-stroke,
water -cooled
Power output/revolutions kW/rpm 21/3000 30/3000
Fuel - diesel
Fuel consumption l/h 4,0 4,9
Fuel tank capacity l 20 15
Lubrication - forced with full-flow oil filter
Starter - electric
Oil charge l
2,8(SAE 15W-40)
3,8 (SAE 15W-40)
Max. engine inclination
o
25 in all directions
Battery V/Ah
12 V, 55 Ah 12V100Ah
Maintenance
- Any servicing of the chipper should be carried out by authorised persons
only.
- Check up the machine for completeness and its general condition.
- Pay special attention to safety elements.
- Check up V-belts for tightness and wear.
- Keep regular intervals for lubrication of bearings.
- Check up condition of blades and chipping wheel vanes regularly.
- Check up hydraulic hoses for wear. Replace them if necessary or every
five years.