3 0
having all rotary parts stopped (after about 1 minute) use an elastic rod
and try to release clogged material in the end piece of the discharge duct.
Turn the duct over the towing bar of the chassis which you may use as a
ramp for standing. Having clogging materials released try to turn on the
chipper again. If not, hinge away the upper hood part and try to remove all
materials by hand (chipper OFF).
Ch
ChCh
Chipping
ippingipping
ipping
The chipper is driven by an engine. Do not start it in confined or
ill-ventilated spaces or under conditions of low visibility.
-
- While chipping you may let the chipper coupled to a towing vehicle. Just
turn the loading chute and the discharge duct in required direction.
- Wooden chips can be gathered in bulk or into a container located on a
towing vehicle.
- When discharging into a container pay your attention to ejecting to avoid
ejecting chips back out of the container. Be careful at turning and going on
uneven ground. Set the discharge duct if necessary.
- Do not load materials with parts of metal, glass and other similar objects.
- Do not chip or load materials while driving.
- Having put materials in the loading chute/between the loading rolls release
loaded materials immediately and keep a certain distance from the chute.
- While working, never lean over the loading chute and never pull out
wooden materials, already loaded, from the chute.
- Do not load materials with diameters exceeding 150 mm.
- If loaded materials are spreading with risks of catch holding of attendant's
dress being drawn in the loading chute then it is necessary to prepare
such materials accordingly.
- Pay special attention to thorny materials, such as acacia and roses, which
may easily catch your sleeves.
- Be careful while loading since materials may unexpectedly move in
unwished directions.
- In case of two attendants it is necessary to make simple signals clear
before working. During operation it is not easy to make any agreements
because of operating noise.
- Observe the working area. If any person, children or animals approach
while chipping, then stop working immediately.
- As far as possible load the chipper evenly, adapt loading speed
accordingly and keep continuous chipping.
- While loading, stand aside the loading chute.
To Next Page
Loading...
