Lauda RE 415 G - Defining the Number of Program Loops (Loops)

09/2021 ECO Gold 105 / 134
17.5 Defining the number of program loops (Loops)
Programs can be processed many times.
- The submenu Loops appears by selecting and confirming 
Programmer  Program n .
- Select and confirm Loops with or and .
- Enter the desired number with or .
- Confirm your choice with the enter key .
Note: To enter two or three-figure numbers move the cursor to
the appropriate point and change the figures with or .
If "0" is entered, the program is continuously repeated.
- By pressing (ESC) you are returned to the menu level without any change.