42 / 134 ECO Gold 09/2021
7 Operation
Always follow this safety information:
Control head drops into bath
Make sure that the control head mounting is securely joined
to the bath.
Addition of liquids with low boiling points (e.g. water to hot oil), alter-
ation of liquid properties
(reducing the flash point)
Explosion, burns, scalds, fire
Site the device in suitable premises.
Avoid dripping water and condensation.
Do not position any small parts and liquids above the device.
Keep the cover on the thermostat (if present) closed.
Prevent the ingress of secondary liquids (e.g. from custom-
er's heat exchanger).
Do not work with liquids in the direct vicinity of the device.
Check the heat transfer liquid at least every six months (e.g.
mixing ratio with a hydrometer).
Skin contact with heat transfer liquid or hot / cold surfaces
Burns, scalds, frost bite, impacts, cuts,
snagging
Only operate the device with its housing.
Avoid splashes and hand contact with hot or cold heat trans-
fer liquid.
Use CE gloves, protective clothing and eye protection.
Affix the symbol "Hot surface".
Do not touch the connecting and drainage points in the op-
erating state.
To Next Page
Loading...
