Lauda RE 415 G - Interface Modules; Menu Structure of the Modules

09/2021 ECO Gold 111 / 134
19 Interface modules
19.1 Menu structure of the modules
From this overview all menu points which cannot be executed in practice are masked out.
off
on
no
Yes
Set-point temperature
Calibration
external actual temperature
Factory calibration
Pump power
Status
Job function
Voltage 0-10V
closed
Interface type
Current 0-20mA
open
minimal value
Current 4-20mA
Main Menue
automatic
maximal value
Calibration
off
on
Analog Input 1
Analog Input 2
Status
Set-point temperature
Analog Output 1
Job function
Controlled temperature
Analog Output 2
Interface type
Internal temperature
Interfaces
minimal value
Temperature extern Pt100
maximal value
Temperature extern analog
Calibration
Temperature extern serial
Set value
Pump power
RS 232
Pump speed
RS 485
extern Pt100
Voltage 0-10V
Cooling valve
Current 0-20mA
Analog Interface
2400
Current 4-20mA
serial interface
Mode
4800
Switch.contacts
Baud rate
9600
off
RS 485 address
19200
Fault
Standby
Programmer
Input 1
Job function
Change mode
Input 2
Contact open
Control mode
Input 3
Contact closed
Output 1
Contact open
intern Pt100
Output 2
Contact closed
extern Pt100
Output 3
extern analog
extern serial
Job function
Diagnostics
off
Temperature range
Error diagnosis
Standby
temperature range
Programmer
Control mode
All Messages
Low level
Overtemperature
Errors only
Expert appendix