LAUNCH ScanPad 071 User’s Manual — Vehicle Diagnosis
15
3.2 Bluetooth setting
Enter ScanPad 071 Bluetooth setting screen (“Settings” --> “Wi-Fi” -->
“Bluetooth”), slide the Bluetooth switch to ON and ScanPad 071 will start
searching available Bluetooth device, tap the desired connector to pair and
match.
By default, the Bluetooth name is 98384*****00 (where ***** stands for 5 digits.).
Note: In case no Bluetooth setting is done before diagnostic software is
launched, you can also configure it while using the software. For details on
Bluetooth connection, please refer to “Chapter 3.5 Start diagnosing”.
3.3 Diagnosis flowchart
For new users, please follow the operation chart shown in Fig. 3-2 to get familiar
with and start using ScanPad 071.
To Next Page
Loading...
