LAUNCH
8
2 Initial Setup
2.1 Charging the Tablet
*Notes:
•
Only use the included power adaptor to recharge the tablet. Use of any other adaptor will damage the tool. We
assume no responsibility for damage or loss resulting from using other similar adaptors other than the specified
one.
•
Always charge on a non-flammable surface in a well-ventilated area.
To check the battery power level, press and hold the Power button about 3 seconds to turn on the tablet.
Power level is indicated as a percentage in the upper right corner of the screen. If the power level drops
below 10% while the tablet is on, a “Connect Charger” notification will appear on the screen.
1. Charging with the included 5V power adaptor
1) Connect one end of the power adaptor to charging port of the tablet, and the other end to the AC
outlet.
2) The charging LED illuminates solid red and the charging symbol will appear on the screen.
3) Once it illuminates solid green, it indicates that the battery is fully charged. Disconnect the power
adaptor from the AC outlet.
2. Charging with the docking station
1) Locate the charging slot on the bottom of the tablet and docking station. Align the charging slots,
and then dock the tablet into the station to ensure that it is firmly seated on the docking station.
2) Insert one end of the included power cord to the charging port of the docking station, then the other
end into the AC outlet. The charging LED illuminates solid red while charging.
3) Once it illuminates solid green, it indicates that the battery is fully charged. Disconnect the power
adaptor from the AC outlet.
Press and hold the POWER button for about 3 seconds to turn on the tablet. The system starts
initializing and then enters the home screen. To turn the tablet off, press and hold the POWER button
until an option menu appears. Tap
Power Off
.
2.2 Screen Layout
The following on-screen buttons are available on the bottom of the screen.
- Tap to visit the official website.
- Tap to capture current screen and all captured screenshots are stored in the Screenshots folder.
- Shows whether the VCI is connected properly or not.
- Tap to display a list of applications that are currently running or recently used.
- Tap to jump to home screen.
- Tap to return to previous screen or exit the application.
2.3 Adjusting Screen Brightness
The tablet is equipped with a built-in light intensity sensor. It can adjust the screen brightness according
to the ambient light intensity automatically. Alternatively, you can also adjust it manually.
To Next Page
Loading...
