LAUNCH
25
*Note: Before performing this function, please make sure that: 1) You have saved a pre-repair report of the
currently tested vehicle; and 2) You have already made some repairs and service and cleared the DTCs after the
pre-repair reported is generated. Otherwise, no differences exist between the pre- and post- repair reports.
Clear DTCs:
Tap to clear the existing diagnostic trouble codes.
*Note: Clearing DTCs does not fix the problem(s) that caused the code(s) to be set. If proper repairs to correct the
problem that caused the code(s) to be set are not made, the code(s) will appear again and the check engine light
will illuminate as soon as the problem that cause the DTC to set manifests itself.
6.2.2 System scan
This option allows you to quickly scan which systems are installed on the vehicle.
6.2.3 System selection
This option allows you to manually select the test system and function step by step.
On the test item selection screen, tap
System Selection
, the screen displays as follows:
Tap the target system (take
ECM
for example) to navigate to the diagnostic function selection screen.
To Next Page
Loading...
