LAUNCH
21
• Tap the input field to directly, tap
OK
. If the VIN exists on the remote server, the system will enter the
diagnostic function selection screen.
• Tap to launch the VIN recognition module.
Place the VIN inside the viewfinder rectangle to scan it. The most recognizable location for this
number is in the top left corner on the vehicle’s dashboard. Other locations include the driver’s door or
post, and the firewall under the hood.
• Tap to switch the display mode of the screen.
• Tap to turn the camera flash on.
• Tap to choose it from the record list if the VIN of the vehicle has been scanned before.
• Tap to input the VIN manually if the tablet has failed to decode the VIN of the vehicle.
• Tap to scan the VIN barcode.
• Tap to scan the VIN character.
*Note: In general, vehicle identification numbers are standardized - all contain 17 characters. VIN characters
may be capital letters A through Z and numbers 1 through 0; however, the letters I, O and Q are never used in
order to avoid mistakes of misreading. No signs or spaces are allowed in the VIN.
After scanning, the screen automatically displays the result.
If the VIN scanned is incorrect, tap the result field to modify it and then tap
OK
. To scan it again, tap
REPEAT
. If the VIN exists on the remote server, the system will enter the diagnostic function selection
screen.
6.2 Local Diagnose
Tap
Local Diagnose
to enter the vehicle selection page.
2 approaches are provided for you to access the vehicle diagnostic software. Choose any one of the
following ways:
To Next Page
Loading...
