Launch X-431 IMMO PAD - Page 7

LAUNCH
3
1. Memory Card Slot
Insert a memory card for storage extension.
2.
Data I/O Port
• Connect it to the SmartLink C V2.0 device to perform vehicle diagnosis.
• Connect it to the add-on module to extend the functions of the diagnostic tablet.
3.
Charging Port
Charge the tablet via the power adaptor.
4.
Volume Buttons
Adjust the volume.
Note: Press and hold [POWER] and [VOL -] key to capture the current screenshot.
5.
Power/Screen Lock Button
To turn the tablet on/off with long press, or lock the screen with short press.
6. Microphone
Convert voice into an electrical signal.
7.
Charging LED
It illuminates red while the tablet is charging. Once charging is finished, it will illuminate solid green.
8. Ambient Light Sensor
Sense the amount of the ambient light present.
9. Front Camera
Snapshot the view ahead the screen.
10. Touch Screen
Indicate the test results.
11.
Camera Flash