LDARtools phx42 - Electrostatic Requirements

UNCONTROLLED IF PRINTED 47
Rev2.18
5/19/2022
Added Flame Arrestor Cap warning back after removal of the Glow Disk
replacement work instruction from the Level 1 Repair section. The warning now
appears in the external parts overview (pg. 8); removed “Probe Flow is blocked.
Check Probe/Change Filter” error from When to calibrate your filter detection
value (pg. 23); added “troubleshooting” to Level 1 Repair advisory at start of
section (pg. 25); revised index.
2.19
5/25/2022
Added advisory to step 2.d (pg. 13) not exceed 1800 psi when filling with H
2
;
removed “Recommended” from “Recommended Probe Flow Rate” (pg. 32)
2.20
6/9/2022
Revised registration instructions for Level 1 certification online training,
removed “Ease of Use and Safety Features” section (pg. 34).
2.21
6/16/2022
Revised “12v” to “12V Max.” for the power supply type under the “Battery and
Charging” section (pg. 34, 37, 42).
2.22
7/22/2022
Added LDARtools Box web address to the Firewall Whitelist (pg. 5).
2.23
8/31/2022
Added section on continuous monitoring (pg. 16); added reminder about not
disconnecting the charger by pulling on the cord, using the charger connector
only (pg. 15).
2.24
11/22/2022
Added updated version of the “Big Picture” quality system image (pg. 6), added
QR codes in the phxApp section for both the connecting/ignition and self-check
processes (pg. 17, 23).
2.25
12/05/2022
Added line to Fill Adapter/Port tech tips regarding action to take when a filter is
missing from the v2 fill port; also added photo demonstrating fill port types (pg.
14).
2.26
1/9/2023
Added section detailing instructions for Extension Probe preparation (pg. 9),
updated index.
2.27
1/31/2023
Updated “Creating Daily Calibration Reports” section (pg. 26) with additional
text detailing requirements for creating digital calibration records.