The PI parameters of the speed loop. The default
values are suitable for most of the application, you
don’t need to change them. Contact us if you have
any question.
This parameter affects the static torque of the motor.
This parameter affects the dynamic torque of the
motor. (The actual current = open loop current +
close loop current)
This parameter is set to control the Alarm
optocoupler output transistor. 0 means the transistor
is cut off when the system is in normal working, but
when it comes to fault of the drive, the transistor
becomes conductive. 1 means opposite to 0.
This parameter is set to enable the stop clock of the
drive. 1 means enable this function while 0 means
disable it.
This parameter is set to control the Enable input
signal level, 0 means low, while 1 means high.
This parameter is set to control the Arrival
optocoupler output transistor. 0 means the transistor
is cut off when the drive satisfies thearrival
To Next Page
Loading...
