Leb Electronics CTR50 User Manual

28
ENGLISH
“Far Storing” - Alternative procedure of code entry (only for Rolling Code remote controls)
The receiver on the card is ready for remote self-learning of SMARTYs (programmed in Rolling Code) and ROLLYs when it has at least one already
memorized remote control code. The procedure to be carried out is the following:
a) Press on the new remote control to be entered the required key for at least 6 seconds, until the switching on of the Led DL1.
b) Press on the already memorized remote control the operation key. The Led DL1 on the card will switch off while the blinker will switch on with fixed
light (until the key is pressed), signalling that the new remote control has been memorized. In case of failed recognition the Led DL1 keeps
switched on for 10 sec., then it will automatically switch off (operation end).
WARNING: The receiver on the card comes from manufacture without any pre-set working mode (Fixed Code, Rolling Code or Secret key).
The first remote control entered will determine the working mode and, once established, it is no more possible to modify it. The sole way to
bring the card to its previous conditions is to programme it again at Leb’s premises.
G) Setting of work and pause times
Programming procedures
The access to programming is given by the key P3. There are 4 different ways to enter upon programming:
 Press P3 for 3 sec. and wait for the Led DL1 switch on with steady light, to program work times of the wings.
 Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 once before the Led DL1 switch on with steady light, to program pause time.
 Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 twice before the Led DL1 switch on with steady light, to program the delay in
opening of motor M1.
 Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 three times before the Led DL1 switch on with steady light, to program the
delay in closing of motor M2.
Note: After the first press of the P3 key for 3 sec. (programming start), the subsequent key presses must be carried out after each flash of
the Led DL1 (max. 3).
Programming of work times for wings
 The programming of times for the leaf 1 is performed using P1
 The programming of times for the leaf 2 is performed using P2
 Program the times for the leaf 2 by means P3 when you wish that the leaf 1 works with the same times (only one programming for both leaves).

Leb Electronics CTR50 Specifications

General

Brand	Leb Electronics
Model	CTR50
Category	Controller
Language	English