25
14) Electrical and mechanical features
Dimensions and Weight of card: 170 x 90 x 46 mm - 0,26 Kg
Power transformer: CTR50 - 230/20Vac 100VA
CTR50\PW - 230/20Vac 170VA
Stand-by power consumption: 1
W about
Working temperature: from 0 to + 60 °C (inside)
Motors power supply: CTR50 - 24 Vdc - 80 W max (total)
CTR50\PW - 24 Vdc - 120 W max (total)
Blinker power supply: 12Vdc - 5 W max
Open gate lamp power supply: 12Vdc - 1 W max
Electric lock power supply: 12
Vac 15 W max
Accessory power supply: 12
Vdc 3 W max
Battery charger capacity: 0,1 A
Relay contact capacity: 30 A
Amperometric Stop regulation: from 50 to 87%
Programming of motor work time: 60 seconds max
Programming of delay in opening M1 and delay in closing M2: 300 seconds max
Programming of pause time: 300 seconds max
Operating frequency: 433,92 or 868,35 MHz
Warning: The unit must not be switched on if the connected loads or the power supply exceed the a.m. limits. Failure to observe this
precaution can result in damage to people, animals or objects for which the manufacturer cannot be held responsible.
15) Electric connections
On the card 6 electric connectors can be seen:
a) J2 10 poles portable terminal board for the connection of controls and safety devices
b) J5 2 poles terminal board for the connection of the aerial cable
c) J1 10 poles portable terminal board for the connection of power devices
d) J3 8 poles portable terminal board for the connection of stroke ends and safety sides
e) FS1 - FS2 n°2 Faston for the connection of buffer battery
f) FS3 - FS4 n°2 Faston for the connection of power electric transformer
Terminal board J5
Terminal 1 - Aerial cable connection (shield)
Terminal 2 - Aerial cable connection (signal)
Faston FS3 - 20 Vac power coming from the electric transformer
Faston FS4 - 20 Vac power coming from the electric transformer
ENGLISH
To Next Page
Loading...
Need help?
General
