CS20, Operation
27
4.1.7 Connecting to a Personal Computer
Install Leica USB
Drivers
Connect USB cable
to PC for the first
time step-by-step
Step Description
1. Start the PC.
2. Insert the Leica USB card.
3. Run the SetupViva&GR_USB_XX.exe to install the drivers necessary for
Leica Nova devices. Depending on the version (32bit or 64bit) of the oper-
ating system on your PC, you have to select between the three setup files
following:
• SetupViva&GR_USB_32bit.exe
• SetupViva&GR_USB_64bit.exe
• SetupViva&GR_USB_64bit_itanium.exe
The setup has to be run only once for all Leica Nova devices.
4. The Welcome to InstallShield Wizard for Leica Viva & GR USB drivers
window appears.
Ensure that all Leica Nova devices are disconnected from your PC
before you continue!
5. Next>.
6. The Ready to Install the Program window appears.
7. Install. The drivers will be installed on your PC.
For PCs with Windows Vista or Windows 7/Windows 8 operating
system: If not already installed, Windows Mobile Device Center will
be installed additionally.
8. The InstallShield Wizard Completed window appears.
9. Check I have read the instructions and click Finish to exit the wizard.
Step Description
1. Start the PC.
2. Plug the GEV234 cable into the field controller.
3. Turn on the field controller.
4. Plug the GEV234 cable into the USB port of the PC. The Found New Hard-
ware Wizard starts up automatically.
5. Check Yes, this time only. Next>.
3
2
4
008508_001
To Next Page
Loading...
