Leister UNIPLAN 300 - Understanding LED Status Indicators; Handling Warning and Error Messages

9
Press "e-Dri-
ve" (31)
Set value is imple-
mented straight away
and the selection
jumps straight back to
the function display.
Selected
function is
executed.
Selection of the marked
position.
Rotate
"e-Drive"
(31)
Setting the desired
setpoints in 10 °C or
0.1 m/min incre-
ments.
Changing the
position in the
function display.
Changes the position within
the Setup menu
Setting the value of the
selected position
LED status display
Heating
The LED on the Heating "On/O" key (28) displays the respective condition of the heating.
LED status (30)
Heating On/O (28)
Condition Cause
LED o Heating is turned o.
LED flashes green
Heating is turned on. Temperature
is not at setpoint.
LED continuously green
Heating is turned on. Temperature
is at setpoint.
LED flashes red Warning message for heating.
See the Chapter Warning and er-
ror messages (UNIPLAN 500) 22 [8]
LED continuously red Error message for heating.
See the Chapter Warning and er-
ror messages (UNIPLAN 500) 22 [8]
Drive
Warnings and error messages
LED status (30)
Drive On/O (29)
Condition Cause
LED o Drive is turned o.
LED continuously green Drive is turned on.
LED continuously red The drive has an error.
See the Chapter Warning and er-
ror messages (UNIPLAN 500) 22 [8]
If, during operation of the drive, a warning message occurs in the Status display “area 2” (35) or if there is
an error message in the working display (33), then this will be displayed as follows:
Heating and drive LEDs flash green
simultaneously
Error or warning
See the Chapter Warning and er-
ror messages (UNIPLAN 500) 22 [8]
The LED on the Drive "On/O" key (29) displays the condition of the drive.