2
Leister WELDPLAST S2 / S2-PVC / S2-TPO
Hand extruder
Extrusion welding of the following materials:
WELDPLAST S2 PP / PE-HD / PE-LD
WELDPLAST S2-PVC PP / PE-HD / PE-LD / PVC-U
WELDPLAST S2-TPO PP / PE-HD / PE-LD / TPO
Other materials on enquiry
The welding seam shape of the hand extruder does correspond to norm DVS 2207–4.
DVS: Deutscher Verband für Schweisstechnik
Application
Please read operating instructions carefully before
use and keep for further reference.
Operating instructions
GB
Danger to life!
Danger to life when opening up the tool, as live components and
connections are exposed. Before opening the tool, unplug from the
mains supply. Electrically conducting material (e.g. PE-EL) must not
be welded.
Fire and explosion hazard with incorrect use of the hand extruder
(e.g. overheating of the material), especially near combustible
materials and explosive gases.
The tool must be operated under supervision.
Heat can ignite flammable materials which are not in view.
The machine may only be used by qualified specialists or under
their supervision. Children are not authorized to use this machine.
For personal protection on building sites we strongly recommend
the tool to be connected to a RCCB (Residual Current Circuit
Breaker).
The voltage rating stated on the name plate of the tool must
correspond to the mains voltage.
In case of a power outage, the main switch and the drive must be
switched off (loosen lock).
Danger of getting burned! Do not touch exposed metal parts
and escaping plastizised material. Do not point the hot air flow
and escaping plastizised material in the direction of people or
animals.
Protect tool from dampness and wet.
FI
120
230
Warning
Caution
Connect the tool to a mains socket with protective earth.
Every interruption of the protective earth inside or outside of the
tool is dangerous!
Only use extension cables with protective earth!
1
To Next Page
Loading...
