5
Operating
Working environment / safety
When interrupting the welding, the drive is to be
switched off with the drive on/off switch (2).
With the handle properly adjusted and firmly tightened,
place down the manual extruder on a stable and
fire-proof surface as shown in the figure.
The hand extruder must not be used in inflammable environments or where
explosion hazards exist. Ensure stable positioning during operation. The
connection cable and the welding rod must remain unimpeded and must not
hinder the user or others during operation.
Rest the hand extruder on a fireproof surface! Hot metal parts and the hot-air jet
must have sufficient clearance from the surface and walls.
Handle Adjustment
1. Loosen the clamping by turning the handle (6) in
counterclockwise direction.
2. Adjust handle (6) to the requested working position.
3. Tighten handle clamping again by turning handle (6)
in clockwise direction.
Workplace
For starting operation of and placing down the hand
extruder, Leister offers a universal device stand.
1
2
3
To Next Page
Loading...
