LEM Analyst 2050 - 1. INTRODUCTION; Introduction Overview; Safety and EMC Standards

2
1. INTRODUCTION
The advanced design of the Analyst ensures reliable and
accurate measurements under a wide range of operating
conditions. Measurement features include:
• Non-intrusive AC/DC current
• True RMS, Crest Factor and THD for complex and
distorted waveforms
• Volts / Watts / VA / PF / kWHr
• 3 Phase measurements
• Screen SAVE mode
• MIN, MAX, AVE, REC Mode with time stamp
• Internal and PC Data logging*
• Multi parameter and waveform display modes
Additional Features Analyst 2060
• Live harmonics analysis and display
• Ripple measurement
• Extended memory for data logging
The Analyst conforms to the latest international directives
and standards concerning safety and electromagnetic
compatibility.
• European Low Voltage Directive 73/23/EEC and
93/68/EEC
• European EMC Directive 89/336/EEC and 93/68/EEC
Safety Standards
IEC 1010-1: 1992-09 Safety requirements for electrical
equipment for measurement, control and laboratory use.
Part 2-032: 1994-12 Particular requirements for hand
held current clamps for electrical measurement and test.
Part 2-031: 1993-02 Particular requirements for hand
held probe assemblies for electrical measurement and
test.
600V Cat IV (750V cat III) Pollution degree 2
EMC Standards
RF Susceptibility and Emissions
BS EN 61326 : 1998 Electrical equipment for
measurement, control and laboratory use – EMC
requirements.
RF Immunity. Annex C. Performance criteria A
RF Emissions. Limits for Class B equipment.
FCC Part 15 Class B
*Requires optional WinLog accessory