24
• Frequently inspect the test leads and the instrument
for damage. If the instrument is physically damaged
or does not function properly, it should not be used.
USE ONLY SUITABLY RATED VOLTAGE TEST
LEADS TO IEC 1010-2-031. (600V CAT IV Pollution
Degree 2).
6. BATTERY REPLACEMENT
Replacement with other than the specified batteries will
invalidate the warranty.
Fit only Battery Type 1.5V Alkaline MN1500, IEC LR6 or
equivalent x 6.
- + will appear on the LCD display to indicate that the
minimum operating battery voltage has been reached.
To change the batteries, see Fig. 8
• Switch off the instrument
• Undo the retaining screws (A and B) on the
battery cover and lift the cover clear of the unit.
• Replace the used batteries
• Ensure the battery cover is replaced and the locking
screws tightened, before further use.
Fig. 8
Battery Replacement
SAFETY WARNING
Before removing the battery cover, make sure
that all external voltages are disconnected from
the instrument. For certainty remove all leads
and unclamp the instrument.
B
A
To Next Page
Loading...
