LENCO Auto Glide - Smooth Water Conditions: Transition - Hole Shot to Planing Mode

11
2. SMOOTH WATER CONDITIONS: TRANSITION FROM HOLE SHOT MODE TO PLANING
MODE: After deploying the trim tabs, the Auto Glide monitors the boat’s GPS speed in preparation for the
transition from HOLE SHOT MODE into PLANING MODE. As soon as the boat passes 12 MPH and the
boat’s pitch angle begins to decrease, the Auto Glide begins to retract the trim tabs as the boat approaches
the HOME PITCH DEFAULT POSITION
.
NOTE:
THE AUTO GLIDE WILL NOT CORRECT FOR ROLL WHILE IT IS IN HOLE SHOT MODE. ROLL
CORRECTIONS ARE MADE ONCE THE BOAT REACHES ITS HOME PITCH DEFAULT POSITION AND THE
AUTO GLIDE TRANSITIONS TO PLANING MODE.