27
IV. MANUAL OPERATIONAL MODES
MANUAL OPERATIONAL MODES allow you to manually control the trim tabs and stops ALL automatic boat control
decisions. There are two types of MANUAL OPERATIONAL MODES:
A. MANUAL MODE
B. LIMP HOME MODE
NOTE:
Although the AUTO GLIDE defaults to “AUTO” mode when you first start your motor(s), it is important that you
understand the two MANUAL OPERATIONAL MODES so you can take manual control of your trim tabs at any
time.
A. MANUAL MODE:
ACTIVATE MANUAL MODE: Manual Mode is activated by pressing any of the UP/DN Buttons while the Auto
Glide is in any of the four (4) AUTOMATIC SETTINGS (AUTO, FAV 1, FAV 2 or HOLD). As soon as you touch
any UP or DN button, all automatic boat control decisions stop
and you assume full manual control of the trim
tabs. The four (4) UP/DN buttons control the trim tabs the same as any of the existing Lenco manual trim tab
switches.
To Next Page
Loading...
