LENCO Auto Glide - Rough Water Conditions: Transition - Hole Shot to Planing Mode

13
4. ROUGH WATER CONDITIONS: TRANSITION FROM ROUGH WATER HOLE SHOT MODE TO
PLANING MODE: After retracting the trim tabs, the Auto Glide monitors the boat’s GPS speed and pitch
angle in preparation for the transition from ROUGH WATER HOLE SHOT MODE to PLANING MODE. In
most rough water conditions, it takes longer to get on plane than it does in smooth water conditions.
Sometimes the conditions are so rough that the boat might not ever get on plane.
In ROUGH WATER HOLE SHOT MODE
, the Auto Glide will begin to make automatic corrections to changes
in roll angle after the boat is going faster than 12 MPH, but has still not transitioned to PLANING MODE.
However, no automatic pitch corrections will be made until the boat’s CURRENT PITCH POSITION reaches
the Auto Glide’s HOME PITCH DEFAULT POSITION and transitions to PLANING MODE.