Figure 61. ServeRAID-BR10i adapter cable connection
Figure 62. ServeRAID-M5015 adapter cable connection
• ServeRAID-M10i adapter: Take the signal cable that is attached to the drive backplane for drive
bays 0 through 3 and connect it to the connector on the ServeRAID adapter connector that is
closest to the power-supply cage. Connect the other signal cable so that is attached to the drive
backplane for drive bays 4 and 7 and connect it to the other connector on the adapter.
456
System x3550 M3Problem Determination and Service Guide
To Next Page
Loading...
