Bezel screws
Video connector
screws
Figure 94. Screws removal
Step 6. Remove the screws from the video connector.
Step 7. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on the bottom of the
bezel disengages from the chassis and set it aside.
Figure 95. Bezel removal
Installing the bezel
Use this information to install the bezel.
To install the bezel, complete the following steps:
Step 1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
Step 2. Rotate the bezel upward to the server and reinstall the bezel screws.
Chapter 5. Removing and replacing components 481
To Next Page
Loading...
