Figure 67. ServeRAID M5000 advanced feature key installation
Step 5. Reconnect the power cord and any cables that you removed.
Step 6. Install the cover (see
“Installing the cover” on page 425).
Step 7. Slide the server into the rack.
Step 8. Turn on the peripheral devices and the server.
Removing a hot-swap fan assembly
Use this information to remove a hot-swap fan assembly.
Attention: To ensure proper server operation, replace a failed hot-swap fan within 30 seconds.
To remove a hot-swap-fan, complete the following steps:
Step 1. Read the safety information that begins on
“Safety” on page v and “Installation guidelines” on page
417
.
Step 2. Remove the cover (see
“Removing the cover” on page 424).
460
System x3550 M3Problem Determination and Service Guide
To Next Page
Loading...
