Figure 77. Virtual media key removal
If you are instructed to return the virtual media key, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Installing the virtual media key
Use this information to install the virtual media key.
To install the virtual media key, complete the following steps:
Step 1. Read the safety information that begins on
“Safety” on page v and “Installation guidelines” on page
417
.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see
“Removing the cover” on page 424).
Step 4. Align the virtual media key with the mounting tab and slide it down the tab onto the connector on
the system board. Press the virtual media key down into the connector until it is firmly seated on
the system board.
470
System x3550 M3Problem Determination and Service Guide
To Next Page
Loading...
