Figure 96. Bezel installation
Step 3. Reinstall the video connector screws.
Step 4. Reinstall the hard disk drives and drive bay filler panels into the drive bays.
Step 5. Install the cover (see
“Installing the cover” on page 425).
Step 6. Reconnect the power cords and any cables that you removed.
Step 7. Slide the server into the rack.
Step 8. Turn on the peripheral devices and the server.
Removing an optional optical drive cage
Use this information to remove an optional optical drive cage.
To remove an optional optical drive cage, complete the following steps:
Step 1. Read the safety information that begins on
“Safety” on page v and “Installation guidelines” on page
417
.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see
“Removing the cover” on page 424).
Step 4. Remove the DVD cable (see
“Removing the DVD cable” on page 484).
Step 5. Remove the DVD drive (see
“Removing an optional DVD drive” on page 441).
Step 6. Remove the bezel (see
“Removing the bezel” on page 480).
Step 7. Slide the optional optical drive cage out of the chassis and set it aside.
482
System x3550 M3Problem Determination and Service Guide
To Next Page
Loading...
