Figure 76. USB embedded hypervisor flash device installation
Step 6. Reconnect the power cord and any cables that you removed.
Step 7. Install the cover (see
“Installing the cover” on page 425).
Step 8. Slide the server into the rack.
Step 9. Turn on the peripheral devices and the server.
Removing the virtual media key
Use this information to remove the virtual media key.
To remove the virtual media key, complete the following steps:
Step 1. Read the safety information that begins on
“Safety” on page v and “Installation guidelines” on page
417
.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see
“Removing the cover” on page 424).
Step 4. Grasp the virtual media key and gently slide it up and off of the mounting tab.
Chapter 5. Removing and replacing components 469
To Next Page
Loading...
