Figure 97. Optical drive cage removal
Installing an optional optical drive cage
Use this information to install an optional optical drive cage.
To install an optical drive cage, complete the following steps:
Step 1. Read the safety information that begins on
“Safety” on page v and “Installation guidelines” on page
417
.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see
“Removing the cover” on page 424).
Step 4. Remove the bezel (see
“Removing the bezel” on page 480).
Step 5. Slide the optical drive cage forward into the optical drive bay until the screw holes on the drive cage
align with the screw holes on the chassis.
Figure 98. Optical drive cage installation
Step 6. Install the bezel (see
“Installing the bezel” on page 481).
Step 7. Install the DVD cable (see
“Installing the DVD cable” on page 485).
Step 8. Install the cover (see
“Installing the cover” on page 425).
Step 9. Reconnect the power cords and any cables that you removed.
Step 10. Slide the server into the rack.
Chapter 5. Removing and replacing components 483
To Next Page
Loading...
