Operator information
panel
Release tab
Figure 113. Operator information panel assembly installation
The following illustration shows the cable routing for the operator information panel. The following
notes describe additional information when you install the cable:
• You may remove the optional optical drive cable to obtain more room before you install or
remove the operator information panel cable.
• To connect the operator information panel cable on the system board, press evenly on the
cable. Pressing on one side of the cable might cause damage to the cable or connector.
• The operation information panel cable should go in between the Video/USB cable (on the
bottom) and the CD/DVD cable (on the top) when all three cables are installed in the server.
496
System x3550 M3Problem Determination and Service Guide
To Next Page
Loading...
