2.Prepareyourserver.See“Removingorextendingtheserverfromtherackcabinet”onpage55.
3.Removetheservercover.See“Removingtheservercover”onpage55.
4.Removethecoolingshroud.See“Removingandreinstallingthecoolingshroud”onpage58.
5.Locatethehot-swaphard-disk-drivebackplane.See“Servercomponents”onpage23.
6.Removealltheinstalledhot-swapharddiskdrivesanddummytrays(ifany)fromthehard-disk-drive
bays.See“Installingorreplacingahot-swapharddiskdrive”onpage104.
7.Recordthecableconnectionsonthebackplaneandthendisconnectallthecablesfromthebackplane.
8.Pressthetwolatches1inthedirectionasshownuntilthelatchesaredisengagedfromthechassis.
Carefullyliftthebackplanestraightupalittlebitsothatthesmallhooksonthechassisarealignedwith
thecorrespondingholesinthebackplane.Then,movethebackplanetotherearofthechassisto
releasethebackplanefromthehooks.
Figure91.Removingthehot-swaphard-disk-drivebackplane
9.Touchthestatic-protectivepackagethatcontainsthenewhot-swaphard-disk-drivebackplanetoany
unpaintedsurfaceontheoutsideoftheserver.Then,removethenewbackplanefromthepackage.
Note:Carefullyhandlethebackplanebyitsedges.
Chapter6.Replacinghardware117
To Next Page
Loading...
