Install an intrusion switch
Use this information to install an intrusion switch.
About this task
Attention:
• Read “Installation guidelines” on page 92 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Touch the static-protective package that contains the intrusion switch to any unpainted surface on
the outside of the server. Then, take the intrusion switch out of the package and place them on a
static-protective surface.
Step 2. Insert the intrusion switch and push it in the direction as shown until it is fully seated.
Figure 71. Intrusion switch installation
Step 3. Connect the cable of the intrusion switch to the intrusion switch connector on the system board.
For the location of the intrusion switch connector, refer to “System board components” on page
45.
146 ThinkSystem SR645 Setup Guide
To Next Page
Loading...
