2.5-inch/3.5-inch drive backplane (signal)
Use the section to understand the cable routing for signal cable connections for 2.5-inch/3.5-inch drive
backplanes.
Your server supports the following server models with:
•
“4 x 2.5-inch front drive bays (SAS/SATA)” on page 63
• “8 x 2.5-inch front drive bays (SAS/SATA)” on page 64
• “4 x 3.5-inch front drive bays (SAS/SATA)” on page 67
• “4 x 3.5-inch front drive bays (AnyBay)” on page 71
• “10 x 2.5-inch front drive bays (AnyBay)” on page 75
Notes: The 10 x 2.5-inch AnyBay backplane can also be used on the following models:
•
“10 x 2.5-inch front drive bays (NVMe)” on page 77
• “10 x 2.5-inch front drive bays (8AnyBay + 2NVMe)” on page 80
• “10 x 2.5-inch front drive bays (6SAS/SATA + 4AnyBay)” on page 82
• “10 x 2.5-inch front drive bays (6SAS/SATA + 4NVMe)” on page 86
• “10 x 2.5-inch front drive bays (6 SAS/SATA + 2 AnyBay + 2 NVMe)” on page 88
62
ThinkSystem SR645 Setup Guide