Configuration 1, 2, and 3: (front drive bays only)
Con-
fig.
Front BP
System board
Storage controller
SFF 16i RAID/HBA CFF 16i RAID/HBA
1
NVMe 0-1
PCIe 3
NVMe 2–3
PCIe 7
SAS 0 PCIe 2
SAS 1 PCIe 4
SAS 2 PCIe 5
2
NVMe 0–1
PCIe 3
NVMe 2–3 PCIe 7
SAS 0, SAS 1
Gen 4: C 0
Gen 3: C 0, C 1
SAS 2
Gen 4: C 1
Gen 3: C 2, C 3
3
NVMe 0–1
PCIe 3
NVMe 2–3 PCIe 7
SAS 0 C 0
SAS 1 C 1
SAS 2 C 2
PCIe 8 MB
The following illustration shows the cable routing for the configuration 2, the routing for configurations 1 and
3 is similar. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Note: For models that support Gen 3 and Gen4 adapters at the same slot, the illustration shows only the
cable routing information for Gen 4 adapters, the routing and connector information is similar for Gen 3
adapters.
Chapter 3. Internal cable routing 83
To Next Page
Loading...
