Lenovo ThinkSystem ST250 V2 - Page 102

– Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
Attention:
• Read the
“Installation guidelines” on page 61 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
To install an optical drive, complete the following steps:
Procedure
Step 1. If necessary, remove the plastic bay filler from the optical drive bay.
a.
Press the tabs on the side of the plastic bay filler of the optical drive bay.
b.
Remove the drive bay filler as shown.
Figure 48. Removing the plastic bay filler from the optical drive bay
Step 2. If necessary, insert two of your fingers into the holes in the EMI shield and carefully pull the EMI
shield out of the chassis.
94 ThinkSystem ST250 V2 Setup Guide