Step 2. Insert the tape drive into the lower drive bay, and slide it in until it is obstructed. Gently pull the
metal tab on the side of the chassis, and then continue to slide the tape drive in until it snaps into
place.
Figure 51. Installing a tape drive
Step 3. Connect the power and signal cables to the rear of the tape drive. See “Optical/tape drives” on
page 39
.
Install the server cover
Use this information to install the server cover.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• S014
Chapter 3. Server hardware setup 97
To Next Page
Loading...
