3.5-inch hot-swap backplane
Table 14. 3.5-inch hot-swap backplane connectors
1 Power connector
2 SAS/SATA connector
2.5-inch hot-swap backplane
Table 15. 2.5-inch hot-swap backplane connectors
1 Power connector
3 SAS/SATA 0 connector
2 SAS/SATA 1 connector
Power distribution board
The illustrations in this section identify the connectors on the power distribution boards.
Two types of power distribution boards are supported by this server:
• “Power distribution board for the fixed power supply” on page 31
• “Power distribution board for hot-swap power supplies” on page 31
30
ThinkSystem ST250 V2 Setup Guide
To Next Page
Loading...
