• Remove any locking device that secures the server cover, such as a Kensington lock or a pad lock.
Watch the procedure
A video of this procedure is available at YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
Procedure
Step 1. Remove the server cover.
a.
Loosen the thumbscrew that secures the server cover with a screwdriver.
Note: The thumbscrew is an integrated part of the server cover. Do not try to remove it from
the server cover.
b. Slide the server cover towards the rear of the server until the server cover is disengaged
from the chassis.
c.
Pivot the server cover outwards and remove it from the chassis. Place the cover on a flat
clean surface.
Figure 25. Removing the server cover
Attention: For proper cooling, always install the server cover before powering on the server.
Operating the server without the cover properly installed might result in server component damage.
Remove the front door
Use this information to remove the front door.
Chapter 3. Server hardware setup 67
To Next Page
Loading...
