Figure 42. Installing a PCIe adapter
After this task is completed
Depending on the type of the PCIe adapter, you might need to connect any required cables.
• After installing RAID adapters, see
Cable routing for hot-swap drives with hardware RAID to complete the
corresponding cable routing.
• After installing M.2 boot adapter, see
“M.2 adapter” on page 38 to complete cable routing.
• After installing the following RAID adapters, see
“Intrusion switch and RAID flash power module” on page
38
to complete cable routing for the RAID flash power module.
– ThinkSystem RAID 9350-16i 4GB Flash PCIe 12Gb Adapter (with flash power module)
– ThinkSystem RAID 9350-8i 2GB Flash PCIe 12Gb Adapter (with flash power module)
Install a 2.5-inch drive into a 3.5-inch drive bay
Use this information to install a 2.5-inch drive into a 3.5-inch drive bay.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
88 ThinkSystem ST250 V2 Setup Guide
To Next Page
Loading...
