Lenovo ThinkSystem ST250 V2 - Install a Simple-Swap Drive

Watch the procedure
A video of this procedure is available at YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
Procedure
Step 1. If a drive filler is installed in this drive bay, remove it first. Keep the drive filler in a safe place for
future use.
Step 2. Make sure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
clicks in place.
Step 3. Rotate the drive handle to the fully closed position.
Figure 46. Installing the hot-swap drive
Install a simple-swap drive
Use this information to install a simple-swap drive.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Chapter 3. Server hardware setup 91