Step 1. Align the slots on the backplane with the tabs on the drive cage, and insert the tabs into the slots.
Step 2. While pulling the plunger, slide down the backplane until it clicks into place; then, close the plunger
to secure the backplane.
Figure 32. Installing the hot-swap drive backplane
Install the 3.5-inch simple-swap drive backplate
Use this information to install the 3.5-inch simple-swap drive backplate.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the
“Installation guidelines” on page 61 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
Procedure
76 ThinkSystem ST250 V2 Setup Guide
To Next Page
Loading...
