Step 1. Position the backplate on the drive cage so that the tabs on the drive cage are inserted into the
corresponding slots on the backplate.
Step 2. Close the plunger to secure the backplate in place.
Figure 33. Installing the simple-swap drive backplate
Install a front system fan
Use this information to install a front system fan.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• S009
CAUTION:
To avoid personal injury, disconnect the fan cables before removing the fan from the device.
• S017
Chapter 3. Server hardware setup 77
To Next Page
Loading...
