Figure 41. Installing the RAID flash power module and bracket assembly onto the chassis
Step 3. Connect the RAID flash power module cable to the RAID adapter. See “Intrusion switch and RAID
flash power module” on page 38
.
Note: Make sure that the RAID flash power module cable connector is fully seated in place as
illustrated when being plugged into the connector on the 9350-8i or 9350-16i RAID adapter.
Install a PCIe adapter
Use this information to install a PCIe adapter.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
Chapter 3. Server hardware setup 85
To Next Page
Loading...
