Figure 38. Rack latch installation
Step 1. Insert the rack latch tab into the hole in the chassis as shown. Then, align the holes in the rack latch
with the corresponding holes in the chassis underside.
Step 2. Install the screws to secure the rack latch.
After installing the rack latch, reinstall the server to the rack.
Server cover replacement
Use this information to remove and install the server cover.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
S014
Chapter 3. Hardware replacement procedures 67
To Next Page
Loading...
