Figure 52. Front bezel installation
Step 1. Align the three plastic tabs with the corresponding holes in the chassis. Then, pivot the front bezel
inward until it snaps into place.
After installing the front bezel, complete the parts replacement. See “Complete the parts replacement” on
page 178.
Front panel replacement
Use this information to remove and install the front panel.
Remove the front panel
Use this information to remove the front panel.
“Read the
installation
Guidelines” on
page 59
“Power off
the server
for this task”
on page 12
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 60
Before removing the front panel:
1. If the server is installed in a rack, extend the server from the rack.
2. Remove the server cover. See “Remove the server cover” on page 68.
3. Remove the air baffle. See “Remove the air baffle” on page 72.
4. Remove the front fans. See “Remove a front fan” on page 75.
5. Remove the PCIe adapter holder. See “Remove the PCIe adapter holder” on page 80.
To remove the front panel, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku: http://list.youku.com/albumlist/show/id_50483452
Step 1. Disconnect the front panel cables from the system board. For detailed cable routing, see “Front
panel” on page 29.
Chapter 3. Hardware replacement procedures 83
To Next Page
Loading...
